sys
嚯嚯 发表于 2020-06-24 14:10浏览次数：
sys命令用于将系统文件从一个驱动器复制到另一个，从而允许启动第二驱动器。
The sys command is used to copy the system files from one drive to another, allowing the second drive to be bootable.
运行sys时，将复制以下文件：command.com，io.sys，msdos.sys和drvspace.bin。
When running sys, the following files are command.com, io.sys, msdos.sys, and drvspace.bin are copied.
目录：
1 sys 运行系统环境
2 sys 语法
3 sys 示例
4 附近信息
sys 运行系统环境
Windows 95
Windows 98
Windows NT
All Versions of MS-DOS
sys 语法
将MS-DOS系统文件和命令解释器复制到您指定的磁盘上。
SYS [drive1:][path] drive2:
|
[drive1:][path]
|
指定系统文件的位置。
|
|
drive2:
|
指定将文件复制到的驱动器。
|
Copies MS-DOS system files and command interpreter to a disk you specify.
SYS [drive1:][path] drive2:
|
[drive1:][path]
|
Specifies the location of the system files.
|
|
drive2:
|
Specifies the drive to where the files are copied.
|
sys 示例
sys a:
在驱动器中的C：提示符下键入该命令，并在驱动器中格式化磁盘，将系统文件复制到该磁盘并使其可启动。
sys a:
Typing this command at the C: prompt with a formatted disk in the drive copies the system files to that disk and makes it bootable.
附近信息
sys.com文件必须在包含系统文件和sys.com文件的驱动器上运行。如果你从正在运行的硬盘驱动器，此命令通常位于C：\ WINDOWS \ COMMAND \目录上的Windows 95，98，NT和2000或C：上\ DOS \目录下的Windows 3.X / DOS 。如果该命令包含所有必需的文件，也可以从可引导软盘运行。
如果在启动计算机时收到“缺少命令解释器”的提示，则可能表明缺少command.com。要解决此问题，请使用sys.com和command.com从磁盘启动，从A：\>键入sys c :，取出磁盘并重新引导计算机。
The sys.com file must be running on the drive that contains the system files and the sys.com file. If you're running from the hard drive, this command is commonly located in the C:\Windows\COMMAND\ directory on Windows 95, 98, NT, and 2000 or in C:\DOS\ directory on Windows 3.x / DOS. This command can also run from a bootable diskette assuming that it contains all the necessary files.
If, when booting your computer, you get "Missing command interpreter," this could be an indication of missing command.com. To resolve this issue, boot from a disk with sys.com and command.com, type sys c: from the A:\>, remove the disk and reboot the computer.